|
Home
Storefront
Browse Sections
|
|
|
|
 |
Jenny Compressors F12C-30C-460/3 1/2-HP 30-Gallon Tank 3 Phase 460-Volt, Single-Stage Simplex Electric Climate Control Compressor
Price : $951.00 $951.00
Features
: - Pump RPM: 590
- CFM Displacement: 2.9
- Del'd Air: 1.7
- Each unit is filled with Jenny Ultimate Blue compressor pump oil
- Manual tank drain
Average
Customer Rating : Not
yet rated |
| Customer Review :
No review yet |
 |
Quincy Air Compressor - Duplex, 7.5 HP, 230 Volt 1 Phase, Model# 271CC12DC
Price : $6,899.99
Average
Customer Rating : Not
yet rated |
| Customer Review :
No review yet |
 |
Sumex 2707015 12 Volt Air Compressor 260 PSI
Price : $59.99 $26.99
Features
: - Air Compressor with reading pressure gauge
- 260 Psi Air compressor
- Plug Directly into your Cigarette Lighter
- Uses DC 12 Volts
- Tire design
Average
Customer Rating : Not
yet rated |
| Editorial Review :
This 12 Volt air compressor 200 PSI stores easily and is designed for light occasional use. It's ideal for inflating flat tires on the road, an air mattress while camping, or blowing up summer pool toys. This 260PSI capacity and on-board pressure gauge are comparable to other higher-priced compressors.
Customer Review :
No review yet |
More
Results : [First] [Prev] 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12
|
|
Questions & Answers
Question : Where do I take an air compressor to get repaired?
I have an air compressor that can't build up any pressure. The pump runs, but the pressure stays near zero. I can't figure out where to take it for repairs. I've called a lawn mower shop, a pump repair shop, and an electrical repair shop. None of them work on air compressors. Any ideas?
Answer:
1 look in owners manual..they have service/repair places listed or # to call2 no book? yahoo/google search the neme brand3 phone book4 unless its a 500+ priced compressor its usually not worth repairing..
|
Question : what is wrong with my air compressor pressure switch?
I have a air compressor with a Furnas style switch with a bleed off valve. My compressor works fine until the set pressure is reached and the bleed off valve is opened. When this happens the bleed off valve bleeds off the pressure in the tank and the compressor cycles again over and over and over. is the bleed off valve bad or does it have a check valve before it? If its at all possible can I just put a cap where the bleed off valves hose runs to on the tank?
Answer:
Sound like you have a sticking pressure switch. You DON'T want to cap off the bleed line, as this could cause too much pressure to build up in your reservoir, possibly causing damage to your compressor or yourself. Your switch will be easy to replace, and not too expensive.
|
Question : what is the best air compressor for both home repairs and heavier work?
I'd like an air compressor that will allow me to do small jobs like a brad nail gun, pump up tires, etc.. Occasionally, I do some larger projects where a nail gun would be nice. However, I don't do that very often. I've looked around on the internet and it is quite confusing. Any suggestions?
Answer:
i would go with craftsman compressors for a start. at least 125 PSI. i have a 12 gallon and i do nail gun jobs all the time with it. i would say either 12 or higher. depends on what you want to spend.
|
Question : How do i use an air compressor?
im trying to fill up a blow up boat and i know you can use an air compressor to fill it up but i cant remember how?
Answer:
If your air compressor has a service hose, that is the line that you hook your air tools onto, you need an attachment which will be able to inject the air into the boat. Either a tyre pump attachment or if you have one a pistol grip type air blower.Once you are set up with the correct bits the boat will have an air fill valve with either a screw cap over it or a plug.Simply turn your air compressor on to charge the cylinder and stick the filling jobbie into the fill valve and pull the trigger.The boats take a lot of air so your air compressor will kick in and probably keep running untill the boat is inflated. Stop filling every 5 minutes or so and let the compressor fill with air and shut down as the little compressor motors get fairly hot.Happy boating.
|
Question : What value is there in air compressor tank sizes?
If I bought a 2 gallon air compressor or a 200 gallon air compressor, what is the difference, why is it important?I understand that the compressor would have to run more often on a smaller tank, but is this a bad thing?
Answer:
By having the sure volume of air you can operate your tools better, say your blowing out a water sprinkler system, the 2 gallon of air will not do it as theres not enough air to clear the pipes, and the compressor running will not deliver enough volume to do the job, same as an air tool that takes 90 psi to run, having 200 gallons of air will run the tool say 5 min without waiting for more air to run the tool, and the 2 gallon would only turn the tool for say 15-20 seconds before you have to wait for more volume of air to pump up..............
|
Question : What type of pneumatic nailer and air compressor do I use to install crown molding?
I am putting up crown molding and I want to use a nail gun. I also want to get an air compressor that is not too cheap that I can put in my work shop for future projects. I may do some roofing in the future. What type of air compressor should I get? What type of nail gun for the crown molding? I am on a budget. So I don't want to spend any more than I have to.
Answer:
A small kit cost about $ 200.00 Can, the brad nailer is good enough for crown just use a little liqud nails the brads will hold the crown in place, the nailer should take up to 1.3/4 nails anyway
|
Question : What do I need to convert a regular air compressor (for power tools) to a power washer?
They seem similar but different. Normally you buy either an air compressor or a power (water) washer. I want to buy an air compressor, just wondering if it can be easily converted into a power washer.
Answer:
A powerwasher does not use air assit to begin with..it is all hydraulic pressure from the hydraulic pump on it...About all you can use on a compressor to make a power washer will be the tires and the frame to mount the motor/pumps etcetera on.. Pressure washer needs no air tank
|
Question : How exactly does a portable air compressor take in air?
The air compressor runs on fuel. It has a stator and an armature, but what do they do?
Answer:
In simple terms....it takes in air through a one way flapper and and pushes air into a holding tank which has a oneway flapper to keep it in.I know real technical term flapper...thats what they call it on the parts list.
|
Question : What would happen if I hooked up an air compressor to the air intake of my lawn mower?
Just wandering about hooking up a standard air compressor ,like the ones used to pump up bike tyres, to the air intake of my lawn mower and see what would happen.Thanks.
Answer:
You will increase the air pressure on the intake side and then in the combustion chamber, which then will cause over pressure in the chamber and this will loosen the head bolts and cause the head to come off or the mower to shut down. Not worth the cost of a new lawn mower.
|
Question : what type of air compressor do I need to run two roofing nailers or one framing nailer?
I currently have a large framing nailer and a finish nailer. I will be putting a roof on this summer as well. I am wondering what type of air compressor will be the best for this.
Answer:
Just a small portable "pancake" compressor. Available for purchase at Lowe's, Home Depot, etc. But, you may want to just rent one from HomeDepot, or another rental shop in your area. Besure to also get at least 100 feet of air hose that will interface with both gun and compressor.
|
Powered by Yahoo! Answers
|
|